Recent content by hdvato

Price Reduction!

Used KwikLift, powder coated red with approach ramps and dual center wheel service ramps. I purchased this ramp new in 2008. The reason I'm selling the lift is because I no longer need this to service the racecar. This ramp has served me well. This is an original Kwiklift before the new...

I leave mine in the original bag. I cut a 'V' in the middle side of the bag - just big enough to pull a zip tie through without tearing the plastic bag.

So does mine.:thumbup:

Sourced the bits from good 'ol McMaster-Carr:

Test

For some reason, every time I use this little guy it welds a smile on my mug -

Added pics unt price.

SOLD! I know there are a few bicycle gear heads on the board - I have a (partial) Campy Tool kit that is just collecting dust in my garage. It is missing the following bits: - Headset press/mill. - Fork bearing race mill. - Headset cup removal punch. If there's any interest, I'll post up...

I like it! I need to do something similar, what did you use?

What Zeke said; plus I'll add that I have the same number of digits I started with that morning.

Sry, should read the whole thread before I post. I LOVE the NT01's. Here's a shameless pic of mine - Best of luck with your garage!

Is that a set of te37's I see in the upper corner?

Welcome :thumbup:

Mines giving up the ghost. I'm thinking of one of these from Northern Industrial. Not thrilled about the NI logo, but can't beat the price. Any other suggestions?