Recent content by heierlu

@LegacyIndustrial Hey - thanks for the reply! The floor is super smooth, but all of sealer may not still be present. It's been a couple years since it was sealed. Would it be recommended to seal it again prior to application of the Kera-Quartz?

Hey all! Looking for a coating for a shop bathroom. It's 8x12, concrete was poured about a year and a half ago, and was sealed a day after the pour with TK Diamond Seal. I'd like to find a coating that doesn't require grinding. Walls are already framed and trying to grind now would be a...

Yeah, I'm confused by this too. I only want 2 zones. 1 zone with 1 loop, and 1 zone with 12 loops.

I actually don't have the header or boiler yet. Still deciding on which manifolds to go with and which boiler.

Ahhh, I never even considered this! Thank you for this reply - much appreciated! I'm going to be using a 10:1 turndown condensing boiler, so this should work perfect.

Trying to size the circulation pump for my in-floor heat setup. I've got 13 loops of 1/2" 300' runs. I've got 1 zone with a single loop, and a second zone with 12 loops. According to my calculations for the 12 loop zone, I have a demand of 10.8GPM and 9-11 ft of head. I can't seem to find...

I'm finally at the point where I'm ready to get the in-floor heat hooked up in my shop. I'm pretty set on a combi-boiler to simplify the install and to save space in the utility room. As far as the in-floor heat, I've got 13 300' loops. 13*300*30BTU = 117,000BTU I'm in WI, so ground water...

This looks exactly what I'm looking for. Thank you!

I'm having my concrete floor poured in a couple weeks and am looking for recommendations for some type of sealant or coating. The floor will be around 3600 square feet with in-floor heat. Half of the building will mostly be used for storage and the other half I'll be working on cars. There...

What brand trench drain do you guys recommend? Looked at NDS that Menards sells, but seems really flimsy and cheap. Local supply house carries Josam Pro-Plus, but that came in at $3,100 for just 36'. Polylok looks to make a decent one, but haven't been able to see them in person so it's hard...

I'd check your local supply house. They ended up having the best price I could find anywhere and even had it in stock. Most of the supply houses here apparently refer to it as URD, but turns out it's actually USE-2 and RHH/RHW rated on the jacket. I've found that even supply houses have no...

@jblnut - I'd love to see some photos of your setup!

I'm in the process of building my dream shop, and am finally at the point where I need to figure out in-floor heat, and what to do for a boiler. The shop itself is 64'x56'16'. Ladder frame, wood construction built on a concrete foundation (4' frost walls with 6" exposed above ground). Will...

Hey all! Long time lurker. Finally building a shop, so decided I'd make my first post! I'm looking for opinions on the layout I've put together as far as door locations and sizes go. Shop is going to be a 64'x56'16' ladder frame building built on a 4' frost wall with an extra 1' of exposed...

PM’d you as well. Sent from my iPhone using Garage Journal