Recent content by HMS57

It's a 4" jaw, with a 6" jaw opening...WARDS MASTER QUALITY casted on the right side and on the left side is 5455... I need to find a replacement dynamic jaw or with someone has the entire vise, I'm interested in purchasing it. PLEASE e-mail [email protected] or reply back here... Thanks...

bad guys are going to get in if they want...hopefully you won't be home, but if you are I hope your packin...if you have a security system, install a EAR PIERCING device, I mean EAR PIERCING...something that is going to make the bad guy(s) cover up and stick their fingers in their ears and run...

Looking for a complete FEED CYLINDER ASSEMBLY for a Mod # 101.22922 Vintage Craftsman Continuous-Blade Power Hacksaw...From the Craftsman Parts List the item # is GBF-560...or any information that you can forward to me so that I can re-build the one I have... Thanks, Dennis...

Looking for a complete FEED CYLINDER ASSEMBLY for a Mod # 101.22922 Vintage Craftsman Continuous-Blade Power Hacksaw...From the Craftsman Parts List the item # is GBF-560...or any information that you can forward to me so that I can re-build the one I have... Thanks, Dennis...

I have a 12" band saw with a 6" drive pulley on the left side... I also have a 6" belt sander w/8" sanding disc... 2 separtate units both craftsman bought back in the 60's... Question, is there a way that I can run both units off the same motor ? Motor is 1 hp. with shaft on both ends... Using a...

HIBALL...you have pm... Thanks, 'HMS57'

want another son ??? daddy...

would T-8's be better then the T-12's... Thanks, 'HMS57'

I found out that with the T-8's, you need to change from the old T-12 ballast to the T-8Electronic ballast...If not the T-8 will not fire up completely...omo... Thanks, Dennis 'HMS57'

I have a StrongArm M-65 floor jack that needs TLC and a good re-build... Where can I find the kit and instructions to make it go up & down again... Well, it goes down ok, but gettin it up is the problem...My smart a-- wife said, "y don' u put a ****** pill in it"...Should not even discussed it...

Is there a way to figure out if the vise is CAST IRON or CAST STEEL ??? The guy I spoke to about repairing it asked me and I don't know... Thanks, Dennis 'HMS57'

I'll take better pix over the weekend...REALLY APPREICATE the input guys... Thanks, Dennis 'HMS57'

My son slid a 4' pipe over the handle...need i say more...the vise has been in our family since day 1 & i'm going to be 60 a day before elvis' bd...it has been a great vise for eons & holds a lot of sentimetal value with us...if you could have seen my son's face when it popped, he was crushed...

Need help to either replace the broken front jaw & slide shaft or repair my Dad's old Wards Master Quality vise... PLEASE HELP ME !!! 4" jaws with 6" opening, the removable jaws are "C" shaped the vise jaws are male & removable jaws are female... Thanks, Dennis 'HMS57'