Recent content by hockey930

I was able to get the rest of the bracing up and cut out the collar ties. Garage appears to still be standing ;-)

As far as the sliders, here are some pictures of the original sliders. There are two tracks that run all of the way across and two 10ft doors. I currently have a post in the middle of the doors which is going to have to move and become 2 posts, leaving me about a 10 foot opening in the middle...

sorry guys, I will work on this. *I think they should works now, I used to be able to link images straight from google photos, I guess now you have to share the pics first and then copy the url, I guess it makes sense.

Hey Everyone, I have a "2 car" garage with low ceilings that I am doing some small modifications to in order to install a Maxjax lift in. The garage is a total of 25 feet wide (20ft of sliding doors) and about a 5ft area to put lawn equipment on the right side. There are currently 4 collar...

I would not rely on that setup either, I found that since you have to run power to them anyway I terminate 4 wires and then pull 2 out and use them for power (most cameras are only 100mb and use 4 wires anyway), That way there is 1 run going to each camera and it's reliable. I will say I have...

I am all about slapping some **** in my garage, and that's exactly what I have but I will say I have picked up 2 pioneer elite receivers open box from best buy for $200 each. It has every capability you can think of including built in internet radio and wifi. $200 can be steep but just throwing...

Does anyone have access to any single Hilti HIS series anchors? I am looking to buy 1.

Does anyone have access to any single Hilti HIS series anchors? I am looking to buy 1.

Does anyone have access to any single Hilti HIS series anchors? I am looking to buy 1.

double post Does anyone have access to any single Hilti HIS series anchors? I am looking to buy 1.

Does anyone have access to any single Hilti HIS series anchors? I am looking to buy 1.

my thoughts on this are to get a 5/8 in wooden dowel, hammer it in the hole ultill you have about a 5 inch hole (bury it in the dirt below a few inches at least 6in?), fill up the hole just over half way with epoxy, as you put the inset in it should force the epoxy back up the sides and when the...

Yes I am now working on this, I am considering using hilti internally threaded inserts the "HIS" line and cutting them down to 4 inches. They have rough surface almost all of the way up the anchor.

Hey guys I know this issues has been talked about a million times but I figure what's one more time. The issue is what do you do when you have a 4in ish slab and want to use epoxy anchors? The ps2-58 is 5.75in long which would go though the slab. The way these anchors are designed to work is...

just ordered my maxjax yesterday, looking forward to figuring out how the heck to fit it in my garage.