Recent content by huff

Thank you very much for the heads up.

The main engine going on it is a small V6, however there are plans of having a GM LS engine on it occasionally. What's wrong with having a V8 on it? Thank you by the way.

Finally finished the engine stand. I built a head to fit the engines I work on most. Hope you enjoy the pictures.

d.mcfarland: Thank you for the information and links. Dan didn't have any knobs, but he did inform me the screws are acme thread. I've got to purchase a new screw because one was bent. mkat1951: Thank you for the offer. If I can find two I'll send you a message. Farmall 1066: See below.

I recently purchased a KR Wilson Engine Stand. It's missing the knobs that go on the screws on the base. I've circled where the knobs should be in the picture below. Would anyone know where I could find replacements or be able to measure theirs so that I can purchase some that are as close to...