Innovate1's latest activity

Costco - interesting. We are members but hadn't thought of them so will check. Thanks! Just checked. Nothing at Sams or Costco...

Looks like internals and warranty are the same. Only the accessories are different. 1 button vs 3 button remote and more complex wall...

Have Liftmaster 8500W on a 9 x 8 OHD and thinking of putting an opener on the 12 x 12 door. 8500W has worked fine - have read of some...

If it's just a simple IR motion sensor I just googled "replacement flood light motion sensor" and got lots of hits. If they get direct...

On hanging lights from the trusses that should be no issue. No problem running screws or even small lag screws into the trusses (such...

They got it done but as has been noted there are lots of things that could have been done better. On the final steps if the low voltage...

Figure on 2 saws. A big one is needed for large stuff but is heavy and not the best or easiest for limbs and smaller stuff. Sounds...

UGL? Too many TLA's (three letter acronyms :rolleyes:)...

Have a concrete 8 x 18 room under a porch. Hollow core support covered by EPDM sheet and then poured the porch over that so it doesn't...

The cap is in the circuit. Bert is right. White is neutral. Power to red or black depending on desired rotation. Like drawing 1 here...

Many meters accuracy is stated as a percentage of full scale. Not positive this applies to CTs but if so then having twice as big max...

I picked up the Klein from Lowes. Did the job on some axle angles and when using it stuck the to bottom of things and upside down the...

A couple uses... I need to measure the angle of the swing arm on a torsion axle and the accuracy of 0.5 degree is plenty for that and...

Thinking an angle indicator would be useful. The type you stick on something (I think many are magnetic) and it indicates the angle...

I have more conventional trusses and put a whole house fan in and then built a hinged, insulated cover that I close for winter. During...