Recent content by jage

  1. J

    Ideas for attaching to pressboard cabinet doors

    I put these cabinets from Ulitmate in my garage and I'm trying to organize them. One major area I seem to be falling short is inside the doors- I wanted to built a ratchet strap hanging section in my automotive cabinet, and I cannot figure a good way to attach things to the inside of the doors...
  2. J

    Uni-strut and hardware source?

    I'm finally ready to do my garage ceiling, but I don't know where to actually buy uni-strut. I want to make sure I get the right stuff (universal size, not some off size) and also where to buy the connecting hardware. I'm also looking for a gantry style light hoist, and things like roller...
  3. J

    Moving a tool box

    I box each drawer separately, leaving the chest 90% empty. It's an opportunity to clean and reorganize, plus with the way movers have treated our things, I'm glad I've done this every time.
  4. J

    Shared stud wall with house?

    I've removed everything to the studs on 3 sides of the garage in preparation for insulation and drywall. The fourth wall, shared with the walk out basement, turns out to be normal studs with drywall on each side. The house siding doesn't continue and there is no firewall or anything, just...
  5. J

    What to do with ceiling?

    Flat roof.
  6. J

    What to do with ceiling?

    I have parallel chord trusses in my very small garage that I'm refinishing. I'm pulling everything out to the studs, insulating, and dry walling, but I don't know what to do with the ceiling. Currently I shove stuff up there for storage, which is very limited because the trusses are close. I...
  7. J

    Eliminate Garage door sensors?

    So I'm looking at a way to eliminate the sensors, and the "tube them together" trick won't work, because I think it's the sensors that are the problem. I'm getting a 2-1-pause flash, and according to the manual that 3-pause indicates interference. The red sensor is mounted as indicated with...
Top Bottom