Recent content by James168

Cool thanks

Thanks all I think I’m leaning toward the hit-z. They say provides the best anchoring also no need to clean holes, not that I won’t clean them but I guess it’s more forgiving So how have you guys prevent the epoxy from leaking out the bottom. The hilti rep did not know- just said you are not...

Update apple to hilti rep- they recommended the hy 200. Of the rod is 3/4. Then to drill 7/8 hole. I forgot to ask about the rods they sell. Has anyone used their rods? Or which rod do you recomend. I saw hilti has regular threaded rods and some that have a cones and groves on the part of the...

What did you end up using for securing the lift? Wedge anchors or epoxy with rods

Cool thank you!!

Hammer drill. Sure I’ll keep that in mind if I have to redo concrete hopefully epoxy saves me. The wedge anchors didn’t fail instantly. Been using the lift since summer but every time I go retorque I see a few that are popping out slightly. As per manual if more that 2 1/4” above grade then...

Yes I’m sure it’s 6” i was there when they did it. I measured the cavity before they poor concrete

The slab is 6” with rebar. and drilled through it when I put the anchors so I should be able to hammer it through. If not I’m screwed. He holes are 3/4”. So I would have to drill the hole to 7/8? And use a 3/4 rod? How much of the rod need to be embedded What do you about the epoxy not leaking...

Thank you. I know a guy that used a sika product for his lift he said it’s been ok. Im just trying to find out reviews from several people because due to my lack of space I want to use the best product so I don’t have to re do concrete.

I used the appropriate size bit for the anchors I had. 3/4”. Cleaned the hole before inserting anchor. There are drill bits that are 3/4” at the tip only and the shaft is smaller. The bit I had was 3/4 even at the shaft so I think that if you let the drill wonder or tilt slightly it can make the...

Im in Connecticut. Thanks for the help everyone

I have a 9k 2 post lift. I have a few wedge anchors that are pulling Out I try hammering them In and retorquing which work for a while but they are starting to pullout again. Concrete is 3500. I would like to hammer them through and install a threaded rod with epoxy. Which product have you guys...

Hello I’m javing the same problem. A few of my wedge anchors are falling and starting to pull out. I want to try some epoxy. Which epoxy brand did you use, which size drill bit and bolt did you use? Thanks