Recent content by jawesy

Lol it sure is, that's what I was thinking to, thanks 0 Sent from my SM-G920W8 using Tapatalk

Because one does not have the time to go though each thread, I did do a search in here and came up with nothing, Well that would be why I made a thread about it:bowdown:

Thanks, I will post more pics as it goes on Sent from my SM-G920W8 using Tapatalk

Thanks for all the info and help, I will see what I can do Sent from my SM-G920W8 using Tapatalk

Kinda, I just don't want any studs coming to the ground, I want it to be hanging so it's no obstructions underneath it Sent from my SM-G920W8 using Tapatalk

Thanks, it would be along the back wall where I could use the 2 side walls and back wall for support, would need to use some threaded rods to support the front of it, want to see how to connect the threaded rod's for the trusses to handle the weight, use a long board across a few trusses...

Thank you Sent from my SM-G920W8 using Tapatalk

Sent from my SM-G920W8 using Tapatalk

Sent from my SM-G920W8 using Tapatalk

Sent from my SM-G920W8 using Tapatalk

I want it to be hanging, nothing in the way to the ground, I have 14 ft walls and 2x4 engineered trusses 30x30 shop metal roof Sent from my SM-G920W8 using Tapatalk

Im looking for information to install a hanging shelf on my back wall that would span the length of my garage, aprox 29ft long and about 4ft deep and 8ft off the floor, in one corner I and to mount my 80 gallon compressor, any ideas on how to do this properly?

Im guessing no one has used one of these for there infloor heat lol

I am putting 2x6 walls r20 value, and r40 value for the ceiling, I put 2 inch under slap insulation board to Sent from my SM-G920W8 using Tapatalk

Has anyone used the Eco Smart Eco8 for a infloor radiant heater? There web page says For Radiant heating, im wondering if it could be used? and how to setup with pump and everything needed, Thank You