Recent content by JazzBlueRT

https://www.amazon.com/gp/product/B08F9JRZN8/?tag=atomicindus08-20 Will Craftsman, mostly late 80's era sockets fit?

Why did sberry get banned?

Craftsman has a store on Amazon which severely undercuts the prices at Lowes. Judging by number of reviews, Lowes products with 50 reviews have 2,000 on Amazon. I dislike shopping on Amazon, but 25% is a huge difference.

I have a dozen or so of C3 Li-on batteries most are over 10 years old now. When they wont charge, I drain them in the LED flashlight and they they recharge. Not all C3 chargers are the same either. As I understand it there is a slow and a fast charge and the charger has to be capable of...

They chose those names to sell to middle class WASP.

Most air tools are very simple devices and have to be built fairly stout just to work. As long as you keep them oiled and water out of your air line, any pneumatic tool can last a very long time.

Yes, there are a lot of advanced control electronics in the system so I guess that is why.

The further out the signal goes, the easier it will be to get compromised. It takes literally less than 5 minutes to run easily downloaded scripts and run them to get usernames ands passwords. If you go with such a system, you will need to lock down the wifi to known mac addresses.

I am not very knowledgeable on home electricity. Would that basically be splitting the 220v into 2 110v circuits?

Seller confirmed there were 2 units and that the 220v is sold out. As I looked deeper into it, the system is basically an air fryer or convection oven with tubing and sealing for vacuum lines. This is part of a dye sublimation system so I think I am going to just build one from a small...

Yes, there are 2x 1300w elements, an upper and a lower. Here is a video of someone replacing the coils.

IIRC correct older computer power supplies had a slide switch 110/220v and some Dell servers had an auto-sensing power supply that could be used on either a 110v or 220v circuit. This is a Ebay seller and before I drop $600 on it, I need to make sure. Have contacted the seller to clarify.

Thank you. The merchant says the machine can be used with either 110v or 220v. Is that possible?

Thank you

I am looking at a new heat press which is 2800w. I cannot get another 25 or 30 amp outlet installed for the 110v version. It also comes in a 220v version. Will my 220v 20amp circuit power the 2800w press? Am I safe on the 220v 20a up to 4400w?