Recent content by JBL

I am struggling to figure out what is still available.

Look at having the hole and thread put in the manifold by EDM.

I ran copper lines throughout the garage and into the basement shop during the build; that was 14 years ago. So far so good!

This is what most of the pro teams use: https://www.pegasusautoracing.com/productdetails.asp?RecId=4613&utm_source=google&utm_medium=cpc&utm_campaign=360045&gclid=EAIaIQobChMIpIeRsteP2QIVTCaGCh1sZgYAEAQYBCABEgIg2_D_BwE You get what you pay for.

I purchased one from Global about one year ago to access a storage space above a 12' ceiling.

Sweet!!

Does anyone have experience with the X-Treme branded modular flooring (Snap Lock PLF, Inc.) as is sold at Menards? https://www.menards.com/main/search.html?search=garage+flooring Thanks in advance! John

Sweet!

Nice!

Yes, I figure it is probably an annual job. If I could find a burnisher at a reasonable cost I would do it more often.

I would not have tackled the initial grind/polish on my own; that was hired out. THe floor was supposedly densified, but I would not know if it wasn't. If I continue to have the issue I assume I can apply the densifier at any time? I rented an LLP burnisher for $110/day and bought one of the...

Yes, it was.

About 8 years ago I had my garage floor polished. The results were quite good, but due to eflorescence the finish became hazed and was troublesome. I tried just about everything and had pretty much given up however was told to use a Twister pad on a burnisher. I cleaned the floor and applied...

You can always go to a polished floor; been here done that and have the scars to prove it! Race deck would continue to be a nice alternative as well.

Thanks! Same comments from the tech at Ameripolish. I should be able to pick up the pads and a high speed burnisher around Indy so that will be a Christmas project! Just hope the damn thing doesnt try to run over me like the last time!