Recent content by JC-Ohio

Thanks. Did you use the densifier/hardener before applying the 8505? Edit: Nevermind. I just found the other thread where you answered that question. :)

Hi all, Apologies in advance for the long post. If you make it all the way to the end I promise there is a point :). I’ve spent the last several months reading posts here and elsewhere about floor coatings and I’m finally where I need to make a decision. I’m almost finished building my 60x72...

Thanks for the info. At this point, I don't know what I don't know so I would definitely appreciate a picture or two of how you did the install.

Thanks, everyone, for your input. It is just what I was looking for. Special thanks for @peter94 for the picture. It is very helpful to show the tube layout and also got me to thinking about how to do my floor drain. I was planning a single, round drain in the middle of the floor mainly...

Hi all, I'm getting close to finishing the design of the hydronic heating for my new home workshop. The floor will be 4-inch concrete with 2 inches of XPS below and around the perimeter of the slab. I'm using 1/2" tubing and planning to put it 2 inches below the surface of the slab. I've...