Recent content by Jc737

72% humidity the day I rolled it out. I lightly sanded it out with120 grit.

No, not a new tire. I waited a week before I parked on it. I had good prep. I am leaning towards either waiting too long between coats or I rolled it too thin. My garage stayed a constant 68.4 degrees as it is a finished garage. I waited 14 hours between the color and the final clear coat...

Any ideas what may have caused this? I tried wiping it with a rag dampened with acetone but didn’t help. It’s smooth to the touch. It’s from the front tires of my truck.

I only have about 420sqft so I will be marking it about halfway on the wall. Thanks for the tip!

Nice job! Thanks for sharing as I am awaiting my kit as it shipped!

Fantatic write up! Thank you for the information as I have just started my. project and this is a plethora of information for a noob. I have remodeled my home but first time prepping and coating my garage. Sounds like you pieced out the Polyurea order. Was there a particular reason in lieu...

Thank you! This helps as it had been suggested to use epoxy patch or epoxy with sand to fill the pitted areas. I just wanted to hear if anyone had actually tried Ardex in this situation and if any extra prep was needed after Ardex. I already shot blasted and think I will just make a slurry...

I have a more prep work to do. Shot blasted my garage floor and have some pitted areas and a few uneven spots. Instead of trying to patch all the pitted areas with epoxy patch I was thinking to skim coat with Ardex and let dry before using Polyurea. Has anyone tried this? Thinking it would...

It’s been shot blasted and has some areas of pitting so will probably have to go the epoxy route and I don’t expect it to cover up the pitted areas. I will use one of the vendors supplies to try and fill in the pitted areas to improve my result. I wanted polyurea but I think that will just...

I’m in the process of prepping my garage for coating and the previous owners filled the expansion joints with some type of cement/patch product. There are areas where it was loose and I picked it out. There are also areas that feel solid. So should I remove all the old material? The areas that...

Shot blaster the floor!