Recent content by jd5000

I have both digital and vernier. I resort to Vernier when batteries die on digital and I can't wait to get replacements. But, OP's requirement was no batteries, so vernier is an option for him.

I don't own this specific vernier, and there are more expensive vernier calipers (Starrett, Mitoyoyo, etc). But, .02 mm precision should be more than enough compared to the OP's Chinese made Craftsman. And, any vernier is going to be more accurate that a Fatmax or any tape measure. Vernier do...

If hate digital, could always get a Vernier. Plus, has both imperial & metric https://www.amazon.com/Vsvgmoq-Fractional-High-Hardness-Mechanical-Non-Digital/dp/B0FF1XMHW2?tag=atomicindus08-20

Is it a 103.23120 or 103.23130? Why don't you post a photo?

There is a debate about spin-down after the grinder is shut off. Many feel that long spin downs indicate that the bearings are in good condition and the grinder is well balanced. Others feel that the bearings are dry and need to be replaced or regreased. The grinding noise indicates that the...

That's a tiny hole, I wonder if it would actually work? I'm thinking a small, directed squirt of Super Super Slick Stuff once every few years would be a lot easier and more effective. Thoughts?

Mine was packed full of grease, too when I restored it https://www.garagejournal.com/forum/threads/11b30b4s-vintage-classic-craftsman-drill-press-information-thread.484456/page-9#post-11281238 I ended up cleaning it out during the restore, but didn't see the point of it. Still, I put a light...

If you decide not to make one, I think this is the one I used on mine https://www.amazon.com/dp/B08GFNYBZM?tag=atomicindus08-20

I usually buy from MRO Supply https://www.mrosupply.com. I always pick the Bestorq (made in USA). Total prices are usually cheaper than any other place I've found and they ship directly from factory (so belts are fresh). ex: AX35 vbeltsforless Price & shipping $15.86 + tax...

There are slightly different variations, depending on the year, but these two photos will show you the general difference in size.

They use a larger base on the floor model

I bought an old Delta wood lathe and this was in the box with all the accessories. I am wondering if anyone knows what this is? Is it an accessory for the lathe or was it something else that the seller thought went with the lathe, but doesn't. Note: it has indexed numbers going around the whole...

OK, I get it now. It locks the piece in the lathe at a specific spot so you can use another instrument (plane, router, etc) to form horizontal patterns. Thanks all!

I always buy my belts from MRO Supply, I always order the Bestorq brand (priced right and made in USA not China) and MRO offers free shipping on belts. Like Frank, I prefer the cogged (AX) belts, too. (Note, the inner diameter is usually 2" less, many give an outer diameter, so a 29" belt would...

OK, thanks.......so how do you use it?