Recent content by JGHannoosh

Thanks Franklee for the inputs. My switch is not housed in a phenolic housing but is as shown in the pix below, The contacts were badly burned so I cleaned them with a points file but I'd like to use something like you referenced. I'd prefer not to bypass it but am concerned that its poor...

In addition the model number is 115.5454

Hi I'm looking for a replacement thermal reset switch for my 1/3 Hp split phase dunlap motor from a Craftsman drill press. Motor draws 6A. Any thoughts?

Hi all Thanks for the many suggestions. The best lead I've found is this picture on Vintage Machinery. It shows how to wire the motor. I think I've got it figured out and will send the diagrams and pix once assembled and running. The thermal reset switch isn't the best and I'd like to...

Thanks Larry. No info on the name plate. Am still trying to figure out which internal wire with ring connector goes where. Am not sure I've got it right.

Hi all I have a Dunlap 1/3 Hp Model 115.5454 split phase motor that I need help with connecting the internal wiring. This is the same motor that Franklee restored in late 2015. There is a terminal block in the end bell housing that has two places to attach the ring terminals. There are 5...