Dunlap/Craftsman Thermal Reset Switch

[JGHannoosh]

Hi I'm looking for a replacement thermal reset switch for my 1/3 Hp split phase dunlap motor from a Craftsman drill press. Motor draws 6A. Any thoughts?

 

[JGHannoosh]

In addition the model number is 115.5454

 

[JGHannoosh]

Thanks Franklee for the inputs. My switch is not housed in a phenolic housing but is as shown in the pix below, The contacts were badly burned so I cleaned them with a points file but I'd like to use something like you referenced. I'd prefer not to bypass it but am concerned that its poor condition will cause problems in use.