Recent content by jim1504

Does anyone know if the bottom black frame(under the bottom red drawer) is concave towards the drawer. Mine appears to be bent towards the last drawer but its hard to tell since the bend is pretty symetrical. Thanks

Thanks guy. I picked up some "Tite Seal" tape as rec'd by Kevin. That should do the trick since the leak was small.

Thanks for the response. I havent tried it and couldn't find what black mammy is? Is it a sealant? googled

I have a lean-to shed that is attached to the side of the house. It is leaking where the asphalt shingle meets the brick. There is very limited space at this point (where the shed attaches to the brick wall) as a result of the overhang of the house's roof. Its nearly impossible to get in there...

That sounds like a great idea, thanks!

Hey Guys I diverted the moisture drain on my compressor to outside my garage. Now the problem I have is the staining of the exterior of the house and patio (rust colored) when releasing the drain pressure. Has anyone used some type of filter to stop the rusty water stains? I've diverted it as...

Jabberwalk Are you aware of any lawsuits by franchisees such as yourself against the franchsior Premier Garages as a result of warranty claims? TIA

I've called Premier out for estimates on multiple occasions after first requesting them to fax a copy of their warranty documentation. They failed to show on all occasions. My feeling was that they were concerned about a future warranty claim.

Thanks for the detailed answer Racedeck. Seems like Racedeck is the answer for commercial applications and also for those wanting a tile that will hold up better over the years.

Racedeck Please answer this previous question when you get a chance: "With regard to the above, are you saying that you consider MotoFloor to be an inferior product compared to RaceDeck? Or merely a similar product with fewer color choices?" Thanks

Thanks Seth. I'll probably order today. Are you using edges near the drywall? Jim

Good luck with your install. I'm near Grapevine, TX. From the pictures of the tile, it appears as though each tile has "male" ends on each side. Are you planning to cut the tile or "male" ends? My garage gets tons on sunlight so I am a little concerned about the expansion. Is your garage...

For those that have installed this tile, may I ask what edging you've used. The site states they have both male & female edging. Did you use edging where the tile meets the drywall or did you just trim the tile itself? Also did you use female edging at the garage door opening? Thanks for the...

Thanks guys, I appreciate it! Jim

Hey Guys I want to keep a capacitor on hand in the event that it fails in the future. The numbers listed on the capacitor are: 40 + 5UF 440V 50/60 HZ 70C Is this the correct one at Grainger: http://www.grainger.com/Grainger/items/2GU38 Thanks Jim