Recent content by Joedirt08

Okay perfect can I use the yellow flexible line or do I need to use stainless steel flex line. I know I need to add a drip leg but then I should be able to just connect it up right? Thanks, Joe

The tee will connect in and will have the tab to use for the stub sticking out of the ceiling ? Also what about the cap at the bottom of the tee do I need to seal that somehow since there aren’t any tabs? Quick question on my gas line stub I believe it is considered 3/4” but wanted to ask for...

Okay so draft hood vent, then tee with cap, and then I could use the flexible pipe from the tee to the ceiling connection. That flexible pipe from what I read is single wall besides the fittings on the end is that acceptable. With where my heater is in relation to the ceiling vent it will be a...

Can you look at screenshot and see if these three items should cover what I need. I was going to use the 90 right out of the ceiling, then the flexible piece and then the hood vent connector from the heater. Or will I need two of those hood vent connectors one on each side? I assume the 4" is...

See pictures I included two of the stub out of the ceiling and one of the back of the heater. Any help with size and type of pipes I need will really help. Greatly appreciate it. Thanks, Joe

If I get a picture of the ceiling pipe will you be able to help? Thanks, Joe

What type of pipe do I need to use and when connecting pieces do I need to use screws to hold them together I know on the back of the heater there are two screw holes for the connection there but it talks about not penetrating all the way through what length screws should I used then. Thanks, Joe

I was just going to connect it to the piece that is stubbed out of the ceiling, I saw where it talks about a tee but from what I read in the manual it is only required on commercial installs. I have attached a picture of what it looks like. Thanks, Joe

Guys need some help with my exhaust vent, the house I live in had the garage exhaust vent plumed from the drywall through the attic out to the roof, I just need to connect from my mr heater 50k to the stub sticking out of the ceiling. Trying to make sure I use the right piping. The OD on the...