Recent content by joefrench

Makes sense! I'll give this a look tonight.

Good call! A couple/few washers should do the trick. It’s only about an eighth of an inch difference.

Moving the rollers to the top did the trick. Plenty of clearance now. I’m guessing I’ll need to get some different brackets to get the door to seal better but, quite happy. Thank you for your help! Greatly appreciated!!

Picture of the door closed should be below. The door measures about 1 5/8” Looking into your suggestion now. Nothing installed in front of the door. I’m assuming you mean handles or some such. The angle measures about 6.5* This is what I found when looking into this as a solution. Correct...

Gutman - Yes, the top of the track starts to angle out. I'll have to double check some things to see if it'd clear if it's laid out fully horizontal. We checked some things on the other overhead door and it appeared there'd be room. I think moving the roller alone would cause some issues with...

I recently had a 30' x 40' with 12' walls post frame building put in for a garage. Since then, I've added walls and insulation to one half followed by adding a ceiling. Unfortunately, clearance for the overhead door was not taken into consideration when adding the ceiling. Now the door only goes...