Recent content by JoeyJ

This is for a garage floor that has already been epoxied.

Sikaflex web site is crazy. Too much information. Can someone narrow the field?

I'm looking to seal the expansion joints in my garage. I want to use Sikaflex Self-Leveling Sealant but read it was very thin hence the self leveling. My garage is pitched quite a bit and was wondering if this product will run down the joint an pool up at the other end of the garage floor...

Deleted

Deleted

Sure will.

Thanks everybody for the input. Special thanks to Scotty and Kayla. I did a 180 and decided to bite the bullet and go with a Porcelain tile floor.

If I went this route do you have to wax your floor for the durability or will the clear sealer do the trick?

Not many colors. What about dyes. Is there a water based one that can be used than a gloss clear coat on top.?

Scotty, Can you give me specific product numbers for the stain and sealer. As I said I have about 430 sq ft to do that has a rough broom finish to it. Joe

O.K. What if I leave the bump. Is there a colored stain and sealer in one product? Because if I have to grid down the whole garage than as I see it I might as well go with the porcelain tile broken back and all and be done with it! Joe

This bump I'm taking about runs the length of the garage on either side of the expansion joint. Meaning to say one time it's on the left side than maybe three feet it's on the other than back again. So because of this I don't believe the slab settled but rather was this way from the start. So if...

First let me say hello to everyone on the forum. I've been reading and learning for weeks now. Much appreciated! I just started to finish my 430 sq.ft. attached 2 car garage. Mini split system ordered for heat and air along with paint for the walls. The floors are another matter. They are...