Recent content by josh_m

I picked up one of these last week, minus the motor and starter. Do you have specs on the motor? What frame and what rpm is it? Thx

First paying job with my set up here is the compressor I'm using, I'm going to have to get a 60 or 80 gallon tank set up soon, but it's rated at 22cfm. It's a Emglo JU pump mated to a GE 3hp 17amp motor. Any suggestions on water filter configurations? I scored 2 3/8 Milton filters and a 3/8...

FYI. Just called HF 800# and they dropped shipping charge by 30.00 and gave me the 20% discount. Thanks for the input fellas. Sent from my iPad using Tapatalk

Thanks. The HF site doesn't give good dimensions, that I've seen. I think the largest thing I'll blast in it is, wheels. 16-17" max. The industrial cabinet calls for 18cfm, but I'm thinking I can down size the gun if I have to. Sent from my iPad using Tapatalk

I'm about to pull the trigger on a blast cabinet, does anyone have experience with both floor model blast cabinets from harbor freight? I was wondering how big the industrial model was compared to the red model that they have in the stores. I'm planning on running two 7cfm compressors in...

Sent from my iPhone using Tapatalk

Yea. I'm looking for a good soft brass hammer now. I not going to use it till I find one. Sent from my iPad using Tapatalk

Found this beauty on the ebay. It's 3/4 diameter and 11 inches long. Knurled grips. I've never seen one like it. Have any of you? Sent from my iPad using Tapatalk

That makes sense about it being a spanner wrench/ wheel nut wrench. Thanks for the input fellas. Sent from my iPad using Tapatalk

I'll take a picture on Monday. It's a 85 model taco cart. Sent from my iPad using Tapatalk

Found it in a tool box a picked up a couple weeks ago. Thanks in advance.