Recent content by Justn2025

  1. J

    Voltage/ Wire Speed Jumping

    not just the wire speeds the voltage u set it on fluxuates an should stay steady right? drive rollers are set right a doesnt slip at all, thought it may be sumthing to do w circuit board just the speed digital numbers bouncing around an not staying set where u set them same for the voltage
  2. J

    First Welding Table Build

    Thanks, yes that thought crossed my very mind should have took it to a buddys he has a sweet cnc water jet table/ i have plasma to cut out but if i do it as is would prolly warp pretty bad .
  3. J

    First Welding Table Build

    Thanks Im searching CL all the time tryin to find a good deal instead of dishing out $500 plus,
  4. J

    Voltage/ Wire Speed Jumping

    I have a Lincoln 256 PowerMig have had it for a yr now an why ur welding the voltage will jump from 17 to 21 will not stay steady an wire speed is up an down will not stay where u set it at i have it ran to a 220 volt plug with 6gauge wire ran from plug about 65-75ft to breaker box, is there...
  5. J

    First Welding Table Build

    Yes 3/8 top 4x4 37in tall thanks I was very happy how it turned out.
  6. J

    First Welding Table Build

    No Welder is on cart with Bottle on back, As far as the casters ther 6inch i believe an 325pound rated 15$ a piece at Tractor Supply, Im just waiting for an old machinist vise to pop up sumwhere to finish her off.
  7. J

    First Welding Table Build

    Went ahead an threw it all together yesterday afternoon still lots of little things to add
  8. J

    First Welding Table Build

    Hey Guys This is my First Welding Table Build Project any Suggestions would be greatly appreaciated.
  9. J

    First Welding Table Build

    thanks
  10. J

    First Welding Table Build

    This is My First Table to Build Any Suggestions Would be awseome thanks.
See more
Top Bottom