Recent content by KatanaKid

I have done a search on Spectrum for Rust to Riches . Cant be found . Where can this show be seen ?

Went and looked today . I was wrong . Tucked in the corner of the bench for years , not able to see its face , and used regularly . And meaning to relocate it for years . Although its 1/2 HP . And in storage , check this one out .

Thanks ! I need to get it out of storage . But as I remember it is in working order . Need to check into the HP though . I like that model and may use it to replace the one in the garage . You did a great job on the restoration !

I believe I have the same one stored away in working order . I will check ASAP . What would one be worth if I decide to sell it ?

Here , in south New Jersey is one that could use some help also

Where can I get info on the value of this South Bend And it’s value

Can I get a value on this Arbil. It’s in my family’s basement.

Add ststes it sold Jan 5 ,19 for ---- YOu ready ? $825 :)

Im already in the game . I Found a nice FPU a few pages back

Here is a Columbian I had out in the shed . You boys made me do it ! The blue one is not mine but worthy of a post

That’s on the. To do list. Will do ! 😎

After searching the net . I have found several FPU's that have only one screw in the back My theory of apossible change of the worm may be possible . I have also seen pictures showing wood spacers between the Jaw & plate . With that I decided to add one hole rather than two And all is good now...

To Rusty & Joe Believe me I looked for any tell tale signs of other holes . None were found ! What I did was , I drilled a 3rd hole in the center of the worm nut . Removed the wood from the jaws . Now it fully closes & operates as it should . Who knows what may have happened during its...

That one looks good also ! Thanks . I agree . And believe it should have 2 bolts in the rear . I guess thats why there are 2 holes in what you refer to as the vise nut . I guess illl have to be carefull in alignment and drill & tap 2 more holes & plug the center one . Is it at all possible...

Now that makes sence ! I looked through 80 pages on E Bay , found 3 . All had 2 screws on back . But they were #326 which I believe is 4 in wide Jaw . Mine again is #328 and a 5 in Jaw . Now I could drill & tap two new holes and things would be fine . But I dont want to rush into that just...