Recent content by Keepat

I used white 6” PVC and painted it black Thanks!!

I thought I would share a shelf I made to hold rolls of tape from of a piece of 6” PVC. After cutting it in half I heated up one edge then clamped it with a 2” L angle to flatten one edge, making it easier to screw to the inside of the cabinet. Then using 3” PVC pipe cut in half for the...

Wow that’s cool!! Crazy how time flies! I’m looking forward to working on the next project in the new shop. Thank You! Pat

The Trans Am is restored all original, in 1972 it was a strike year there are only 1286 total Trans Am‘s built. Had to leave that one bone stock, mostly;-) Thanks

I have an original paint 66 GTO, 72 Trans Am that I restored about 14 years ago and my sons 68 bullet mustang that he and I restored 10 years ago. Thank You!! Pat

Just about ready to start getting the tools dirty;-)

Thank you sir! For the most part I used car models in alphabetical order and then on the tool cabinets I used 3 engine manufacturers with their engine displacements for each drawer.

With the floors finished I was able to start mounting all of the cabinets and installing the butcher block countertops. The floor has quite a grade change. I had to custom make The base cabinet toe kicks. The bottom of the cabinet bases are sealed with marine resin. Thanks Pat photo upload...

The slab was only about 3 3/4” thick where the 2 post lift was getting mounted. So we cut 2 48” x 48” holes and back dug under the slab about 8” x 16” deep. After that set about 40 days we followed up polishing the floor and then mounted the new lift. Thanks Pat

I thought I would share my shop project and barrow a few ideas along the way;-) I bought a property about 1/4 mile from my home. It has a small house with an attached 2 car garage and a 32x48x13 detached garage. We will rent the house but keep all the garage space. The 12 year old detached...