Recent content by Kenskip1

Harbor Freight.

Additional information 20 minute video .

I was wondering if anyone has any information on this item. It has some good reviews on FB. https://www.harborfreight.com/12-in-shop-press-brake-attachment-70952.html

I have and still use a Lotos LTP5000D with pilot arc for well over 4 years. And not a problem with it. I purchased it from Home Depo and got a one year warranty with it. However it has been trouble free. Also I purchased the consumables from Walmart at a significant cost savings.

I for one would like to know what make and model of the saw we are talking about. With the chain brake on and at the fast idle setting this may cause the clutch to over heat and cause serous damage. Are there limiter caps on the adjustments? Is this a new saw? if so simply take it to your...

So after thinking about moving up from 1/4 inch ID line and changing to 3/8ths ID am I still use the air fittings from the 1/4 or do I have to make another purchase? BTW, the high flow fittings that I purchased at Lowes are made of aluminum. I would rather have steel.

In a shop air supply, some is good, more is better, and too much is just enough! Stormy Daniels said something similar to this.

So with my high flow fittings now installed on the compressor that I forgot about, I did my usual evaluation. A 1/2 drive was selected and with 150psi I pulled the trigger, Initially the increase was noticeable however after a few seconds the tone went down. I was all set to go online and make a...

So today I went out and purchased high flow fittings, To cut to the chase, yes they made a improvement for a second or two. Then I could hear the air flowing from the compressor to the tool. So I am now on the right track. This small change really made the 3/8 NANO wake up!

First off, my regulator is on my 60 gallon Husky air compressor. I have it set to 150psi. I use mostly a 1/2 drive for lug nuts and the like. However at times I use my 3/8 nano for lug nuts on smaller vehicles. As mentioned when I hook up a 3/8 air hose directly to the compressor my 3/8 impact...

Approximately 45 to 50 foot.

Ok, So about 4 years ago I installed a garage air line kit. The only bad side was that I was totally unaware that the inside diameter was 1/4 inch. So my new plan is to install a larger line with the inside diameter either 3/8 or 1/2 inch. Would the 3/8 over 1/2 inch do or should I put the extra...

This is off topic a bit however, yesterday I received in the mail a statement from Lowes that they are raising the interest rate on your charge purchases to 31% interest. If you don't want to pay this amount they are gladly closing out your account. I called the bank yesterday after reading...

I have had this for about 6 years. I purchased it when sears was closing up shop. $49.95 It is made buy a import company of witch I am not familiar with the name. However it is a bit heavy but it has according to the specks 550 lbs of torque. It likes 125+ lbs of air pressure. And I don't have...

Update, I wanted to check the brakes on my F150. This was the first time I used this. What a huge difference. I should have had one of these a long time ago. Wonderful to have as long as you have air pressure. I have the 10.5 K model