Recent content by kerrylbuxton

Murphy, My dad has the same saw and I would like to add wings to the table. I see your has two. Is there any way you could take a pic of how the wings attach and the construction of the wings? Thanks Kerry Buxton

I bought a 2.500" x 3" 1018 steel plug and turned it to 2.450" except for 1/4". Drilled a 1/2" hole 2" deep and drilled and tapped the plug and 1/2" bar for set screw. Cut a delrin spacer and added a flat steel washer to adjust height of pulley with bronze bushings installed. On top of pulley...

I am going to use a 3" long steel plug to fit into the dp post and thought of using a shoulder bolt and carefully determine the length needed for the pulley and two bushings. Does the 1/2" washer between the nut and bushing ever spin?

Have a 1750 rpm motor and need to turn 500 or less for a hole cutter. Need to remove the high speed pulley and install a slow speed pulley, DP-283-S. Cannot figure out how the pulley is being attached to the spindle. Also saw a couple of homemade speed reducers that use the floor column for a...

Have an old, 25 +, Columbian 604 vise that I would like to disassemble and clean. The vise tightens when opening more than 3-4 inches. I opened the vise all the way but the forward jaw assembly would not come out of the rear. Need to know what is holding them in place.