Recent content by KratosBear

To revive this thread again. I am having this same exact issue and spoke with the “tech” today and they are sending me a new logic board. Were you ever able to fix your issue? If so, what was the fix?

I have an Atlas 8000 EXT. My ceiling is 12’. Had my C8 Z06 stored on there, as well as many other vettes/cars, with no issues.

All bolted down! 1/2” x 2” Drop-in anchors worked perfectly. I used a 1/2” x 1.5” hex bolt, 1/2” split washer, 1/2” washer, and 5/8” drill bit. Some sweat, a hammer drill, compressed air to blow out dust, and rubber mallet to line the holes up did the trick. Also, at the last minute, I...

I scrapped the horse stall mat. The mat was 3/4” high and did feel too spongy. Just going to bolt to concrete and caulk around the bottom of the feet to keep water away

@whateg01 You think a horse stall mat will compress that much being vulanize rubber?

Which length 1/2 bolt did you go with? 1.5”?

This is perfect! Did you use a washer as well with the bolt?

I am interested in bolting down my Atlas 8000 EXT 4-Post Lift. Over time, my lift has moved a few inches and tends to have a slight wobble when my car is on the lift. I am interested in using drop-in anchors. Can others please let me know which drop-in anchor, bolt, washer, and drill size...

I’m in the same boat as you. How are these mats holding up? I like the mats you chose because the holes will have water can drain if needed. Any issues? Do you think you should have gone with a different mat like the one Advantage Lift sells above or a horse stall mat from Tractor Supply