Recent content by Krmnnghia

Finally found the time to install the lift. That was fun. LOL Have to get a few new nuts and things for the ends of the cables and some ATF before I get it in the air. I am still unsure about bolting it down. Some say no need to worry about it but damn for as heavy as this thing is it seems...

Took the holiday to get the lift assembled. 12K Rotary with air jacks. What a heavy son of a *****! Would not even be close to possible without the tractor.

All the walls are white. Now to ad some goodies to the wall!

Slow Progress...but it is progress :D Finally got all the OSB up on the walls and slapped on more paint. My father in law tackled the office exterior wall and used some left over flooring to cover it. Turned out pretty nice I think.

I agree. Was just in there all day cursing at my Yukon’s rusted up hub/wheel bearing and was quite happy with the light.

Thanks!

Unscrew!?!? Oh **** we pinned ours. :wtf: :D

Throwing my 2 cents in. We just started painting our interior. OSB was the most economical way for us to do it and we definately did NOT want to be doing a ton of paint work. We went with Zinsser Cover Stain Primer. 2 Coats and we are very happy with the look.

Ceiling and all insulation are complete! Thank god because damn we’re sore. 800 overhead screws to get it all in. All upper lighting done, fans installed, 220 line for the 4 post lift is all run and ready. The upper loft office is for the most part done. Needs to be trimmed out and the barn door...

I don't ever want to worry about being under 6000lb's of instant death. Let's just hope I don't have to buy too many parts. The cable kits alone are almost what I paid for everything. LOL

Well It was quite a Saturday for me. 2.5hrs to get to the lift and about 2 hours to dismantle and load, then 3.5 hours to get back in the rain and snow. The seller and a couple of his workers handled all the dismantling and loading. Sure helps when you have a 20 ton crane. The lift had a few...

Looking to pickup a used lift, most likely an older Rotary 12K 4 post model. https://www.garagejournal.com/forum/showthread.php?t=433943 I am no lift expert but I know my way around a garage/vehicles. The lift is 2.5hrs away and currently together and fully functional. If everything checks...

Oh Man that is not a glowing review. So the safety locks are air powered? Any bypass for that? I would hate to lose air with a vehicle in the air and not be able to get it down. I have an 80 gallon tank...I would think that would be fine. I assume its standard 220v? Thanks. Didn't know if...

Talking with the person selling, they say it is Blue and I can make out the Rotary symbol on the pump. I'm almost positive it is a SM123-10. Thoughts?

Looking at 4 post lifts and found one on FB Marketplace. Couple Questions. 1. Anyone know what make and model this might be? Rotary? 2. I know little about lifts, but shouldn't have any issues tearing it down and reassembling. What can I check onsite to ensure its a good purchase? 3. Anything...