Recent content by ksarauer

  1. K

    Garage heater needed - seeking advice

    Thank you, this is what I needed to hear. Even though I like the radiant heat over forced air, I'm gonna cross these off the list for the garage. I hadn't considered these, I'l take a look at them. I'm planning on blowing the ceiling once I get it installed. Didn't want to blow it until I have...
  2. K

    Garage heater needed - seeking advice

    If it makes a difference, I'm in central MN, north of the twin cities.
  3. K

    Garage heater needed - seeking advice

    I've got an attached 24x24 garage with 10'6 ceilings. The walls are rocked and insulated, the ceiling is rocked, no insulation yet (will be in the near future). I'm looking to heat it and not sure which way to go, radiant tube or the traditional modine heaters. Will be using NG for fuel source...
  4. K

    Looking for advice on running water line to out building and installing yard hydrant at the same time in MN

    I didn't look at the depth, was kinda thinking 6 ft would be enough, but I see 80" is recommended, I'll be going at least 80. That's a deep trench to dig.
  5. K

    Looking for advice on running water line to out building and installing yard hydrant at the same time in MN

    No, running it from the well would be easier. Well is in front of house, and building is on south side. Well is where the gray marker is. Pressure tank is in the house, and a pretty small tank. all the pluming is between front steps and garage in basement. same here. If I run it through the...
  6. K

    Looking for advice on running water line to out building and installing yard hydrant at the same time in MN

    Hello, we have a out building that is all finished and heated during winter months. I want to run a water line to the building and to a yard hydrant. The outbuilding is completely finished inside and out, with insulation and walls and concrete floors. The yard hydrant I plan on installing...
  7. K

    testing post

    Checking if I can post
  8. K

    Minimum thread count

    Why do I need a minimum post count in order to post to a thread? This was 10 posts, now I get the message I need 20 posts... This is so frustrating...:confused: To reply to threads in this forum your post count must be 20 or greater. You currently have 10 posts.
  9. K

    pic test

    1234
  10. K

    Milwaukee Power Tools Deal Permathread

    Anyone know of a deal on some M18 batteries? I'm looking at something like this... https://www.homedepot.com/p/Milwaukee-M18-18-Volt-Lithium-Ion-High-Output-6-0-Ah-and-3-0-Ah-Battery-4-Pack-48-11-1865S-48-11-1865S/312174410 I'd also go for larger batteries if there's deal on them.
  11. K

    Milwaukee Power Tools Deal Permathread

    I've been waiting for deals on both these items, Perfect!! Only problem is it's online only and they are sold out... Any idea how I can get this deal still?
  12. K

    Cat6 and RG6 to Detached Pole Barn - Need help

    I had this same issue a few months back, and I went with the NanoStation 5AC Loco, they were cheap enough to try out (less than $100 for the pair), and they were small, not much bigger than a deck of cards. Setup was a breeze and they work great! We do a lot of media sharing throughout the...
  13. K

    Security camera help.

    I have a few of the Dahua camera's and looking to add a NVR. Is there any that you'd recommend/not recommend?
Top Bottom