Recent content by KTNC

Geobruin - Extremely helpful, thanks. It looks like the best choice for me is the new dewalt 378. Nothing against the red ones, but already have a lot yellow batteries! Thanks again!

Hello - trying to decide on which cordless portable bandsaw for general shop use…. I really like the size of the dewalt compact, but am concerned that the cut opening is only 1.75 inches…. For those of you that have these is that an issue? And do you find the larger opening is preferred? Thanks

Anyone ever the use the below in your garage? I like to "overbuild" things and am thinking the below would be a good improvement over regular 5/8 dry wall.. Thanks USG Sheetrock® Brand Mold Tough® AR Firecode® X Panels are available in UL Type DesignationAR, and were designed and tested to off...

Thanks guys - "I'm going to say your 10' door isn't wide enough for a GN trailer which is probably 8'6" wide.... " - O/H doors will be 16 wide, 10 is the height. 1). "How wide is the trailer? Parking it in a 20' wide space may not leave much room around it for storage." - It's about 9 ft...

I am looking to expand an existing free standing garage (26x40x12) by adding a three sided building (24x40x12) to the one side. The existing roof will have large partial trusses attached to it so that when finished the addition will appear as if it's part of the original garage. I would like...

Thanks guys. - Yes there will be a concrete floor. - There is no room on the existing garage to add a lean to, due to property lines. - I am not worried about the weight of snow on the roof as much as I am the potential of snow/debris blowing in a structure with no sides... Our...

I have a large gooseneck trailer (about 35 ft length total) and am currently storing it in unattached garage next to my house... I want to turn this unattached, unfinished garage into my work shop (insulate, heat, etc.) so I need to relocate this trailer. I was thinking about having a large...

I am looking to upgrade from a 3/8 Dewalt drill to a 1/2 Dewalt DCD995 XR hammer drill. The drill will get moderate use, but I intend to also use the tool with sockets for quick tire removal, bolt removal, etc... I can't really justify having a separate drill and cordless impact for the...

I am in the planning stages of adding a 24 foot addition to the back end of my existing detached 26x40x12 garage. Basically this as far as I can go due to the property line. Some questions I have: 1. Since when finished it will be so long and narrow, what is the best heat source? It will be...

Hey nice thread GB, just read the whole post. Question on the novistone - it appears you ran this on one side (and front) of the new garage only and not the other side... Why?