Recent content by laminated

wondering of someone had any manual for the Barrett FMC / Bean brake lathe I picked up a B 400 model thanks

yes thats it, non flamable.

one thing they mentioned was mineral oil. so stores or get some from a 2005 and early VW/Audi etc power steering fluid as its mineral oil based.

saw they are on for $75 . Augusta and Savanah Ga both had one there the guy said so call your store if you want one

Post hurricane I;m going to add some straps to a shed at a camp when we go back . and want to build an adapter I saw for the impact gun to screw them in, so wonder, the strap width so I can find square stock to go into to the anchors channel part at the top that the cranking bolt runs...

was a small light had fibre op extension

contacted Snap On re broken Blue Point light. told sorry Not under warranty,so no replacement . was not told that when sold it. Warranty ends when the tool isnt sold any more.

late reply, Issue with Proto is you have to pay to return it for them to Review it, so the cost of mailing it there , plus if denied ,the way back, will cost you as much each way I found as the item is to begin with. Had two things to return and found that out the hard way.

asked and not till email comes out they said.

have this adapter from the 40's or 50's

needed for one day to clear a couple

rare find they arent the Bel air ones . I sold the screwdrivers for 150 and the pick set for 100

saw somewhere the long noses like the LN47acf are out in 2024, any ideas when??

just to ask if someone had either set, I never had the chart so hoping for a copy I can laminate and have with the sets. thx

we did the first HUMS install on a 212, had it at 0.0ips in hover smooth as glass up to 100 on a smooth day.. started on a D Astar then B's etc then super D's. Did Camera installs on a few movies for Production Heli on a few movies.