Recent content by Layerman

That's the route! I pulled the the bolt on the right side that supports the pulley. It's the only way to free up the cable and get it up above the the bottom of the press piston. I slid the pulleys toward the back and routed the cable to the back between the top beam and the springs. I'll...

Thanks for digging! That last picture may hold the key. I'll check the pulleys that ride on top bolts and see if they move front to back. If they do it will allow the cable to route between the top beam and the press springs like the picture. The routing will make a lot more sense this way...

Thanks RTM ,,, I started with that thread and looked the scanned manual. Unfortunately there is any info there that show the cable route. It's odd because everything else it pretty intuitive.

Picked up a Nugier H40-7. I got a few missing parts from the company but they don't have any information on how the table lift cable routes. Looking for some help, pictures or advice on how to properly route the cable. Thanks