Recent content by Lee Berr

I bought it at grizzly.com it's also on page 288 in the 2017 catalog Model G8291 2 HP 22A-30A 110volt $ 94.00 They also have 220volt and 3 Phase.

I use a table saw and a planner a lot, the power went off for 3 sec. while I was using my saw, not as bad as if I was using my planner, made my **** pucker so I bought this disconnect. I was going to build one but after I priced the parts this one from Grizzly cost about $ 30.00 more. I plug the...

Thanks for the info. it was a taper fit, after I posted this I put a small bucket full of rags under the chuck and put a wedge on each side and it came right off. ( it was made in 1950 so the spanner wrenches are long gone) Thanks again for the help..........Lee

I got this drill press from my dad it has a Att. for a mortise set up. to put it on you have to take off the depth gauge collet but the collet for the mortis Att. is smaller than the chuck, does the chuck unscrew or is it a friction fit. my drill press looks just like the picture on the start...