Recent content by LivenLife

I have 12ft ceilings on my 24 x 24 and have 6 of these. I have really liked them. 4 are installed on 1 switch and the 2 center are on a seperate switch. https://greenlightdepot.com/products/lhb-110w-with-lens-and-w-o-lens

I don't know if this will help you or not, but I have 2 of the Canarm (CP56HPWP) that are both run off of a single Canarm speed controller (CP561118111R). They have a slight hum that is louder than your typical house ceiling fans while they are running at low speed, but they are not loud enough...

Sorry guys. Just noticed I put this in the wrong forum. I was able to come home and locate the adjustment screw and got them turning slower.

I had 2x CP56HPWP 56in Canarm Fans installed in the shop. They are wired into a single Canarm variable speed switch w/ reverse. On minimum speed, they are still turning to fast. The manual says there is a minimum speed adjustment screw. Can someone help me out and tell me where this screw is...

I've tried everything mentioned above. I have been keeping a close eye on it. It worked great from Thursday morning to Saturday night with outside temps staying above freezing. Sunday morning we were down in the 20's and the unit shut off. This morning when I checked it at 5:30, the outside temp...

Thanks guys for all the replies. Yesterday I turned the breaker off for 30minutes and back on. Everything was working great. I checked it before leaving for work this morning and it was down to 58degrees in the shop with no air blowing out of inside unit. I checked the outside unit and it...

Well when I got home the unit was off again, so I ran a code check on the remote. It through no code and when I made it back on the 00 normal code it gave me the long beep. I also don't think we have had any power interruptions because no clocks have reset in the house. The manual says it should...

The remote was still on showing the temp, but the inside unit's green light was off and flaps were shut. The building itself was down to 43degrees. So I know it was off all day.

I just installed a Daikin 19 Series 24000btu Mini Split earlier this year. I used the A/C all summer with no problems. I started using the Heater last weekend and have it set to stay at 62degrees. It does a great job maintaining temp in the shop, but for the second time this week, I have come...

Hope you don't mind the mess, I am still working on the inside walls and have to shuffle stuff around. These are the best pictures I have and they really don't do these lights justice.

One more question. I received my Ghostshield today and am going to clear out the shop to start coating. I believe I need to apply the densifier and wait 7 days before applying the Ghostshield. How long after I apply the densifier do I need to wait before I roll stuff back into the shop? It's not...

I actually have 4 lights on one switch and the 2 middle lights on their own switch. Any time I am working in the shop I do have all 6 on. I think it's the perfect amount of light, at least for me. I know my electrician was giving me a hard time for buying 6 ( we hooked the 4 up first to get all...

Ceiling is 12ft.

Well, each to their own I guess. Just because I had to pay return shipping, doesn't mean they weren't fantastic to work with. They had me a new light with out giving me any run around. It's a lower cost Chinese light, which I knew when I bought them. I wouldn't hesitate to buy from them again.

I have the 2 in the middle hanging from chains, for now. Haven't had time to fabricate the mounts yet. I fabricated mounts for the other 4 using some angle iron that was left over from building the shop and these https://www.e-conolight.com/premium-led-high-bay-pendant-mount-kit-e-hld-series.html.