Recent content by lonesouth

I'll second the champion 3650 watt does have 240v via a 30a twist lock. It will run my well, but not my 1.5 ton AC. Regard fuel burn. For liquid fuels, gas/diesel, a general rule of thumb is .1 gal/1kWh. So a 3kW unit running at full load will use a bout .3gph, and a 6kW unit running at 50%...

Wish I had seen this before I got my reciprocating saw package https://www.homedepot.com/p/RIDGID-18-Volt-Cordless-Lithium-ion-5-Tool-Combo-Kit-w-Drill-Impact-Driver-Circular-Saw-Reciprocating-Saw-Light-R9623N/300146409

looks like they are starting to pull these from the site.

A buddy has one of these and swears by it. Next time they have a sale, I'm going to pick one up.

I picked up the reciprocating saw, still a deal at $199 with two batteries. Mostly I'm wanting to get the batteries covered under the LSA(for whatever that is worth). I suspect it will be the next to go OOS.

What are the chances that any of these will be restocked? I am looking at cordless tool packs with batteries included. 5x Impact Wrench - $159 https://www.homedepot.com/p/RIDGID-GEN5X-18-Volt-Brushless-Impact-Wrench-Kit-R86011SB/303037082 5x Circular Saw - $159...

Upgraded my living room speakers and wasn’t getting any traction on selling the old ones, so the garage got an upgrade. Mirage omi-250 mains, klipsch c-1 center, velodyne va-1250 subwoofer. Once I finish the inside, I’ll add a pair of klipsch quintet mains as the surrounds.

I started having some problems with my compressor about two months ago. It would start up strong, but once it got to ~90psi, the motor would slow down and nearly stall. It would struggle along till about 110psi, then it would kick back up to about 90% of the normal speed. I pulled the caps...

shoot it into the air on nights below freezing for snow...Because Florida.

I had an extra ceiling fan, so...

I swear I saw a Lexus LFA pulling out of Bull Run last week. Waiting for it to turn up at one of these car shows.

What is the second car? F Type? I'm going to try to show up to the November C&C with my 77 Bronco. Rick, owner of the blue Cobra, lives behind me, I can hear him crank up from inside my house, he is two houses away.

Got to put my hands on this at the Sunbelt Ag Expo. Fit and finish are good. It is a little lighter than I expected, good for portability, bad for instilling confidence. Trigger was good. I was also able to test it on a 2x4 they had on the table, test for fit, not to cut. For that 2x4 it...

Just dropping in to say hi! Great thread!

Anyone have any experience with Trajan products, and specifically the Q700? From my reading, it is similar to the Evolution Rage 4, but seems to have some better features. I expect the largest metal I'll need to cut is 2" angle, so a 14" saw is overkill, plus the small saw would offer some...