LOW1's latest activity

We are fortunate to have an abundance of decent/adequate/good enough tools that do not cost much more than bottom end/ bad tools but far...

Like many I have mostly switched to battery power tools. But I prefer my corded Sawzall over my battery Dewalt. This is especially true...

Donuts to start the day. Ice cream treats in the afternoon if it’s hot

Anywhere from one to 30 inches

Rightly or Wrongly I suspect that DeWalt refuses to sell to Walmart out of its desire to protect the perceived quality of its brand.

Yes. Up until this summer the dockwork only involved an occasional tightening that only took a minute or two with an old already-rusty...

In our docks and boathouse there are some galvanized nuts and bolts. Some of these are below the waterline. Occasionally these nuts...

As another mentioned that is not an old ******. I am thinking that there is something wrong with the finish or the steel quality which...

I’m thinking that there may have been a factory defect in that ******

That ****** should unscrew easily. If doing so breaks the pipe in the wall that pipe was in its very last days anyway.

Back in the day when they came in paper and not digital form my snowblower really liked to eat newspapers. A thick Sunday paper can be...

I am not sure why this thread is posted in the vintage forum as these gimmicks are still separating fools from their money today...

I am a bit spoiled. Two Aces, Theisen’s, TSC , Lowe’s and a Menards within ten miles. Needed some tiny metric machine screws...

Menards is starting to sell them, mostly online and not in stores. Seems to be focused on solar/electrical/fiber/cable tools. Some...

Perhaps the problem lies in the Design Department and not in the Manufacturing Department?