Recent content by LT5 John

" Doing the same thing over and over again, and expect a different outcome is INSANITY!" :eyecrazy:

Everything you wanted to know about oil... http://www.bobistheoilguy.com/forums/ubbthreads.php?ubb=cfrm

I researched the 3/4 pressure hose for my Quincy compressor. I ordered from McMaster-car-this hose is good for 300psi...http://www.mcmaster.com/#air-compressor-hose/=1142za8

Got these over @ Amazon...They are great, well built...Been using these almost a month, no issues...:beer: PneumaticPlus SAU4030M-N06DG-MEP Three Stage Air Drying System - Air Particulate Filter, 0.3 Micron Coalescing Filter & Air Pressure Regulator Modular

My new Quincy QT 5... http://www.garagejournal.com/forum/attachment.php?attachmentid=538642&stc=1&d=1458685811

Hi Gang. I wanted to install an EATON push button start/stop button on my Eaton Mag start...The Utube video . The video said to red L1, the yellow to 2of3 the blk 3of4?...I have an auziliary on the mag start labeled 13NO and below 14NO...Can I wire blk to 13NO and yellow to 14NO, and red to...

Hard wired my new Quincy QT-5 compressor in and plumbed...excuse the sideways pic http://www.garagejournal.com/forum/attachment.php?attachmentid=533438&stc=1&d=1457213127

The # 8 I am using has all three wires encased in rubber...3 wires, black, white and green...Black to L1- the white to L2 and green is the ground inside the mag start box...This set up is only temporary, I will be hardwiring to the sub-panel...

The main panel is in another garage about 60' from the sub panel. I thought I would hard wire with # 8 THHN? The sub-panel is a surface mount...

The sub panel has a 50A breaker. Just below the sub panel there is a 50A receptacle. The receptacle is less then 4' to the mag starter. I wired the plug and the mag start with #8 THHN. Black, white and a green. I know I have to hard wire the compressor, but I wanted to run it to make sure...

I have a 50A breaker in the sub panel. the outlet is next to the sub panel...Both sub panel and outlet are about 4' from the compressor

Baldor motor, single phase

sorry guys, it posted upside down:headscrat http://www.garagejournal.com/forum/attachment.php?attachmentid=530971&stc=1&d=1456574747

The outlet is right next to the panel-3 prong welding plug ' * ' '

http://www.garagejournal.com/forum/attachment.php?attachmentid=530923&stc=1&d=1456540612