Recent content by lukeembry123

Figured it out. I had cleaned the flame sensor with no luck already, tried again this time sanding with 320 and it fixed it. Thanks for the help Sent from my iPhone using Tapatalk

1 year old big maxx 45k. Only starts up sometimes. 2 flash on the board. Tech service says the board is bad, replaced today and still the same issue. When it fails to start the burnets sound weak. You can tell when it will start because of the strong burner sound. Thoughts? Thanks for any help...

Did you figure it out? Mine is doing the exact same thing. Tech service said the board is bad. Installed a new one and still the same. Sent from my iPhone using Tapatalk

No brand listed anywhere, was hoping someone here would know Sent from my SM-G950U using Tapatalk

Anyone have feedback on these? Sent from my SM-G950U using Tapatalk

No problem getting in the side panels, pics make it look closer than it is. This is a detached garage so nothing else is hooked to the gas, house is all separate. I used about 5-6' of the csst, I'll be grounding it over the weekend. Sent from my SM-G950U using Tapatalk

There's a lot of room behind the heater, I-sheet says keep 18", I'll measure but id guess I have 36". Are you talking about the side panels as the access panel? Main shut off is right outside the door so I didn't bother with one up top. is the wall switch code for where you live? No code...

those are nice instructions, Mr Heater I-sheet doesn't show anything like that or much at all. thanks for posting

Any reason why you say that? I cant find any info that explains why thanks for the suggestions

I live in Ky, there isn't any code for this stuff around here. I don't have anywhere to mount the heater to get the 18" so that's why I'm doing it this way. I have a main fuel shut off right outside my door so I didn't bother with the small valve up top. when you say street elbow are you...

I used the union so I can take it apart if needed, there isn't a flex line, the yellow line is a stainless coated line that runs about 10' in the attic to the black pipe. no idea what a draft hood is

I'm in the process of installing a 50k unit in my shop, I'm limited to 1 place to hang it which has made it difficult to do. I'll add pics so you can see how I'm doing it so let me know if you see issues. I'm venting with class b 3" vertical with a 6" pipe thru the drywall for a thimble...