LXCam's latest activity
-
LHung the high bay lights. Very bright. Too bright. May decide to put them on 2 different switches so only half of them are on with each...
-
LMore assembly photos. Insulation added a ton of time. I used Prodex insulation with an R value of 22. Tons and tons of rattling in...
-
LAfter giving the slab plenty of time to cure, I called up my kids and with our contractor friend, rented a bunch of equipment and...
-
LBuilding kit showed up on the only day we got snow. The road iced over and the semi got stuck coming up a hill and was sliding sideways...
-
LMore site prep after the rock was chipped down. Drainage, sloping, drain rock, etc. Pouring the slab. 45 day cure time before the...
-
LHaha.. Yea, a nickname that stuck and now it lives on. It's the email address that usually gets assigned to me based on my first and...
-
LAnother fan of that Vevor bit sharpener, I've got the same one and it's very good. Quiet, nice range of sizes though wouldn't mind if...
-
LLXCam replied to the thread Greetings from the sunny land of AZ.Howdy from Prescott John and welcome aboard. Also a little advice, if you think free parking is entertaining stay far FAR away from the...
-
LLXCam reacted to lilscorpion's post in the thread Above 1200 Sq/FT LilScorpion’s Fab Space with
Like.
Agreed. That’s how did them for a while but getting smaller bits to turn out was difficult. Probably due to my eye sight starting to... -
LLXCam reacted to SilverJimmy's post in the thread Above 1200 Sq/FT Overcoming Good-Deal-Itis One Project at a Time with Love.
Last Friday a fence contractor started phase 2 of my outside storage yard by concreting all the 2” and 4” steel posts for the privacy...
-
LLXCam reacted to LopezBart's post in the thread Why don’t pullers use acme thread screws? with Like.
Likely because ACME threads are too coarse. Most pullers use fine threads, providing far more force.
-
LI finally decided to replace my small shop vac for home to see if these new DeWalt vacs live up to the hype. Short answer is yes they...
-
LMarketplace comes through again! 🤩 Not sure how old, but I know it’s old.
-
LI just found another casualty of that damn mini PC. When I tried to down load One Drive and had issues, it went berzerk. I got a message...
-
LLXCam reacted to KwikFab's post in the thread Between 265 & 485 SQ/FT Kwik Fab's Small Shop with Like.
From time to time, I'll do something completely free. I may add a stipulation here and there, but one that I find extremely reasonable...