Recent content by markhodges78

Yeah I'm defiantly digging into it. Crazy the one at Northern Tools that's for sell has the exact same part numbers for everything but the parts aren't available for sell.

Below is the Diagram of my pump and it does not look like it has wrist pin bearings.

I have not been able to source crank and bearings

?

I believe it's a b6000 but I have been unable to source a crank and bearings

Well they said it is but they also said the red one kept tripping the 30 amp breaker. Well of course it did the breaker wasn't big enough... so there's no way they didn't know it was knock. I take what they say with a grain of salt .. but they do have a video of it running but it's in a...

Yeah but i can't get a new compressor for 1200 with 26 cfm and this one you posted is 15 cfm wouldn't I be better served to get the one from harbor freight and save some cash if I was going to go down in cfm?

Using a big screwdriver to check.. It definitely sounds like it's coming from the lower area

Using a big screwdriver to check.. It definitely sounds like it's coming from the lower area

Yes for $400 but I don't have the room for a horizontal compressor..

Any opinions on which pump i should replace mine damaged pump with Direct replacement https://www.northerntool.com/products/northstar-air-compressor-pump-2-stage-569cc-22-9-cfm-at-max-psi-45932 Have to change pulley to decrease pump speed...

I could do this one for 600 but would have to change the pully on the motor to slow the pump down some https://a.co/d/9gR9XIY

I feel like for what I have in it I could put a H,F pump on it and run it a few years our I could just put a northern on there and hopefully be good for a while

Honestly I would use it for air tools ( DA's sand blaster plasma cutter ) the CFM's on the current pump is crazy high and even though its not needed id rather have as much of it as possible lol

I did that last night and there is movement a little and it's clanking. So I believe it's something with the crank and bearings, which I have not been able to find parts for the pump