Recent content by mds33200

Hello, with the specs, the size of the machine is 24x72x36 As far as the dust, I would say the sources are from the following: cutting cardboard boxes open (all our products are usually double boxed from the factory and have to be opened and re boxed up with a brand new smaller uline box) We...

I manage a 14,000 foot warehouse and the inside work area is very dusty. No matter how much we vac or sweep the processing area, there is always lots of dust in the air. I located a furniture store in my area that is closing down, and they have a dust collectors they are selling. Below is a...

I have a compressor and it keeps kicking on so I knew it had a leak. As I got closer to the compressor to check for the leak I could hear a hissing sound coming from the PSI adjustment knob. I unscrewed the knob (which should have reduced the outgoing psi to zero) but when I removed the rubber...

At my work we inspect plastic parts and have to check for scratches or anything that could make the item look used in any way, and I was getting a hair cut last week and at the barber shop they had an 18" ring light, (circular light with the middle hollowed out) and its on a stand. I was going...

Hi, at my work, we have some pallet racking which we have to adjust the height of the beams. But this racking is very old, and about half of the pallet beams are held in place with steel rivets. I tried to drill the rivets out but none of the drill bits I have will drill into them. So I...

I was looking at some of the NOCO brand battery jumper boxes and I see they have several models with varying levels of amp hours. The main reason for purchasing is for general use at work (incase someones car dies- just to have on hand since we have about 10 employees) I also have a jetski which...

See the attached photos to see how I am measuring it, I didnt test it yet, I just wanted to confirm if it was "within spec". It had some dust / debris on it, so my concern was they sent a defective unit. So I measured it, and noticed a very slight difference. So figured I would check with the...

Hello, I purchased a 7" circular saw and I measured the distance at the top end (between the fence and where the blade starts), and also measured the distance at the bottom (between the fence and where the blade starts) and there is an offset of about 1/16". I was wondering if this is an...

Thanks! I ordered one off amazon!

Hi, I have a 1/4" drill that I like to use for small electronics, and I was wondering if anyone knows of an adapter so the screwdriver will accept smaller bits? The bits I am looking to use are the standard size mini bits that are included in most mini screw driver kits, such as the one below...

That looks like a very nice one (dewalt 8v) But I click the link and it says it includes one battery. Did you see a different place selling it that included two batteries?

Thanks for the replies. I have a palm sized skill drill, and I have been using this for years and its my favorite drill for disassembling things. I just wish it had a faster RPM. I just set up a spring balancer and that works for now, but still I wouldnt mind spending some moneyy to buy a...

Hi I have a bunch of drones that have to be disassembled (we disassemble them and part them out) and I have tried many different drills, and a basic 4 volt screwdriver seems to be the perfect weight. However when removing screws, sometimes it takes up to 5 seconds to remove the screw because the...

Hi I was looking to buy a solar powered charger that I would be using to charge my ipad. I keep mine in my car and I would not mind just leaving the solar panel on my dash and just running a wire and connecting it to the ipad when the battery is half way down. I was looking on ebay and I found...