Recent content by Mecrez

You need Kinematics, if you are investing in a book, there is also some discussion of Kinematics in the Machinery's handbook. Many people look past the first few chapters and there is often very good information in there. On another note, if you are working with engineering drawings, it is...

That's an Eaton ball pump in the Ebay auction, they are still made new in Iowa, not sure if your model is still available, check with an Eaton hydraulics distributor

I thought I would add to this thread. I found this vise in scrap pile. It looks better than it was since it has been covered in penetrating oil. The vise was completely seized and was a lot of fun to get apart. Mid process shot. I was using electolytic rust removal. You can see the...