Recent content by mike348

Shorted mine out on battery. Wrench on + and ring touching wrench and negative = everything welding together finger slipped out fast with no skin.:shocking:

Need to make some 3/4 " holes 4" deep. Will use a Hilti drill. #6 steel mesh in slab. What will happen if bit runs into mesh?

My son is buying a 30x40 steel building. Just the steel $8500 One 10 ft. door 2 side doors.

Will the very hot air temp affect it?

It's light gray.

Should look great.:thumbup:

I poured and rolled. It was hard to get even coverage. GOOGLE notched trowles for a supplier. It would seem a lot easer to pull the epoxy at a even rate. You can get different size notches.. You can put 100% very thick. It flows out very well. Best part very little if any fumes. I bought it...

[/IMG] Finished my floor yesterday. 900 ft. 100% epoxy. wolverine brand. It took 6 gals. of mixed epoxy to complete. Went OK, I mixed up 1.5 gals at a time. It had 30 min pot life. Used a roller. If I had to do it again I would have another person. One to squeegee it out and one to...

Changed mine out to copper after 17 yrs. I could tell that the PVC pipe was very brittle when I cut it up. :3gears:

Good idea.

I get it at one of the DIY pest control sites. Use a garden sprayer and wet where the ceiling meets the walls. Do one application every September. The stuff has zero smell.

Welcome. There's plenty of good information on this board. :beer:

I buy only name brand tools that I know.

I went looking for a battery and left Lowes with a drill.

I use DEMON powder one bag for a gallon water. No spiders for 2 yrs. :thumbup: