Recent content by mike4

Photo

thanks, appreciate the input & for what it's worth the building just went through the eye of a cat 3 hurricane with no ill effects

I have a 1600sf detached block garage on my property, which i purchased not long ago. I had a new shingle roof put on it right off the bat. They had to replace most of the decking. They said many were termite damaged but so no actual live termites. The trusses are exposed on the inside (no...

would this be sufficient? this is in florida so hvacs always in use pretty much. (2) 200 amp main breakers. is a 320/400 meter base enough? House 2400sf ac / electric heat split system Guest House 1200sf ac / electric heat split system Metal Shop 1700sf (hobby shop not commercial) ac /...

thanks

Gotcha - how much of the 4500 did you use to cover the 600sf?

What sort of coverage has everyone experienced with this specific product? Have approx 2700sf of broom finished 4000psi w/ microfiber to cover. Going to be applying 8505 a week after this goes on.

Goal is to protect the integrity of the building itself to the degree possible. The local power company installs surge protectors at the breaker so to whatever degree possible counting on that to protect co-ax cat 5/6 romex etc.

Putting up a roughly 1700sf A style quonset building in an area which receives the most lightning in the US. I've been told to add six or eight 3/4" x 10' copper grounding rods under the footers & have them tied into the standard copper wire/rebar/ground rod connections. How to go about this or...

Thanks!

What is this?

Thanks.

Ok, so basically it's just worth a few bucks in scrap metal?

This was given to me many years ago. The motor ran last time I checked but I'm sure it needs to be gone through to make fully operational . It has the original base. Does it have any value? Where do you think I should sell it? It's too large / heavy to ship for Ebay etc.

Thanks!