Recent content by millsjq

How do tool boxes and floor jacks on the Exelia? Will it leave marks?

I am looking to insulate and was interested in options. And possibly having a wider door, so I can have lift in one side and park car next to lift.

Two more photos.

Sorry trouble loading photos

Just bought a house that included a metal building that will be my future shop/ garage. Is anyone familiar with this type of building? It is located in Jacksonville Florida

My floor is about four years old and had discolored due to sunlight. I am not going to redo with a UV protected product. My question is I am going to sand my existing floor to get good adhesion and to smooth it out. I have the choice of three sanders at the rental store: 1. A floor...

I just pulled off the plate cover and I was incorrect. I do not have 12/3, I have 12/2, black, white and ground. Considering that I would think that I do not have any options other than using this exclusively for powering the lift motor.

I have an wire run 12/3 to the a ceiling box over where I am about to install a 4 post lift. I will at times roll the lift outside and will need to make a 25' extension cord. I would like to have power to lift and a 110 outlet on thr lift using only one cord my ideas so far. 1. Have a duplex...

Big Dawg, The garage width on the double bay is wide enough, but I was looking at the bend Pak HD-9STX to get a higher lift (so I do not hit my head) when it is up high without a car on it and I am parking under it, but it has a 100" column height that will not fit through by 93" garage door...

I am getting close to pulling the trigger on a left and want to throw out my logic to see if anyone has additional ideas. I have a three car garage (double door and single), my height is limited to 9" 2", to low for a lift to be really effective but I would rather duck or work on a stool than...

I used these: http://www.receptxtenders.com/products.htm The come in different depths and work well for me

A few months ago I saw a post that had picture of a garage where the owner had a ledge around the perimeter of the garage that was drywalled in and was used to store plastic container and other items. I look slick and I wanted to copy the concept, does anyone recall it? Jack

I have a 1,040 sq foot area, in my garage. The floor was pour 3 month ago and I plan on etching with muriatic acid, two coats of color and one of clear. Since my previous garage held up well for eight years ( just demolished) with just the “standard” Rustoleum that is available at Lowes, I...

I have been using a make shift connection to my air compressor and I am in the process for running air lines in my garage. However, I do not know where to get a rubber line to connect the compressor to the air line. Jack

raffaelli, I do not fully understand your suggestion or my photo did not provide enough detail. I attached a sketch of the area, I have about 4 1/4 inches of the block to cover and to match the height of the 2x6 that is on top of the block it would have to be a 2x. From what I understand of...