Recent content by mlcharlestonsc

  1. M

    Installing OSB on interior walls

    Here is mine. OSB walls and celling hung with air staple gun. 2 coats of cheap primer from Ollies, 30$ for 5 gals. No gap fill used. Also if using latex which is water based paint when temps are hot, so it drys quickly and not lift, separate the fiber chips. Otherwise use oil base and you'll not...
  2. M

    RTV tubes.... PITA !

    I quit using tip and re-cap
  3. M

    Cheap Framing Nailguns ?

    I have hb one for 6 years blue one and built fence, shelves, framed cabinets, works great. Also hf has all nails brads staples and supplies you need for their guns. one stop shop.
  4. M

    12'x36' clean slate

    Thank you for all the positive comments. There are 16 light fixtures on the ceiling. Hose reel new off clist, craftsman drop cord reel on clearance, mounted with uni-strut. Work bench being covered with repurposed red oak lath from work.
  5. M

    12'x36' clean slate

    Update, been busy this summer. Back in garage now here are update photos. Please ignore the mess still organizing my stuff.
  6. M

    Deal on CL

    Just picked up both of these coolent flushing machines off CL for $ 125. Robinair has all hoses, tanks and fittings. Wynn missing on/off switch. And they work.
  7. M

    SK Tools Free hat and catalog!

    Got mine last eve. Slipped my mind till it showed up. Nice letter too!! Stop gripin it is our fault they ran out and it took so long. The letter did state that GJ gave an overwelming responce. SK did EXCELLENT at keeping there end of the deal now its time for us GJ's to put our money were our...
  8. M

    12'x36' clean slate

    This was delivered on a trailer. Also no property tax considered portable building, only need one permit and my yard is small. Wanted 16'x38' but largest they make is 12'x36'.
  9. M

    12'x36' clean slate

    Been awhile, here is update. Put tile down tonight.
  10. M

    Thought I would email some tool companies

    Greenlee sent this. Check it out.
  11. M

    Thought I would email some tool companies

    I'll post pix in few min. Recived order by fed ex on mon and tues this week. They should have sent you an email after you ordered items may not have went through.
  12. M

    Thought I would email some tool companies

    I saw that one then found this one. Don't Have enought to start trading yet. Just getting started. Just show what I was getting.
  13. M

    Thought I would email some tool companies

    guess you should report to the Adm to have it moved.
Top Bottom