Recent content by mobius1982

Profile updated. Looking for a 3m bulk pack with all different grits and mandrels. Checked amazon.ca but they only have huge 3m single grit boxes. Also walmart was a bust. Has anyone tried the 3m flap wheel disks that have sponge and sandpaper looked kind of interesting but not sure where they...

Roarksupply does not ship to Canada. Can anyone recommend a place to order 3m roloc discs that is either Canadian or will ship to Canada at a reasonable cost. Thanks, Mobius1982

Anyone know where I could get a starter kit with a mandrel. A few different assorted grits and the mandrel. Not sure yet which grits will be my go to. Thanks, Mobius1982

Can anyone recommend a good brand of roloc discs and mandrels. Want to use them with my die grinder Thanks, Mobius1982

I just ordere a set of Astro Pneumatic 2185 long double cut carbide burrs and a set of Astro Pneumatic 2181 double cut carbide burrs. Can anyone recommend a good set of aluminum carbide burrs. I do not want to use the double cuts on aluminum so I don't contaminate the metal for tig welding...

Wow this has been really great feedback. Since my die grinder is not variable speed and spins at 21000 rpm I think I will avoid the wire wheels with it but the burrs and stones will work great. Thanks so much for all the feedback. Mobius1982

Which wire wheels are you using. The ones I have found so far are not rated for that kind of speed. Also any suggestions for roloc brands to use. I have never purchased them before. I am assuming the 2" ones would be best but which brand holds up. Thanks, Mobius1982

Also anyone have good luck with grinding stones or are they not worth it. Thanks, Mobius1982

I will definitely stay away from the Neiko and spend the extra on the Atro Pneumatic ones. I see your point about the Mac tools ones being warrantied but I can't justify buying them based on my usage. Can I use roloc pads at that speed 21,000 rpm. I think that could be pretty handy. I know the...

Also anyone had any luck with the neiko brand carbide burrs. Thanks, Mobius1982

I will definitely have a look. Since I am new to owning a die grinder with 21,000 rpm. I ordered a 1/8" collet so I could use some small dremel accessories too. Can anyone recommend some other handy 1/4 shank die grinder accessories I was think a small cut off wheel. Since this is a new tool...

I just bought a Milwaukee 5194 die grinder no load speed of 21000 rpm. I would like to buy a set of short and long double cut carbide burs and a set of short and long aluminum carbide burrs. I plan to use them to clean up welds and deburr and enlarge holes in steel and aluminum. Can anyone...

Re: Organizing 1/4\" Bits I bought the bit organizer from Lee Valley for organizing my 1/4 bits. Its comes with 4 screws is about 3/8 thick. The holes are a fairly tight I find myself needing needle nose pliers just to pull some of the bits out. Good product would definitely buy it again.

I will be buying a 14 cutoff saw so any angle cuts are not a big deal. I like the idea of using rectangular bar for a square and then using triangular plate in the corners to support the equipment. Then I would like to use square plate on the top corners to support the wheels. I might stick...

I am looking to do my first welding project I want to build a mobile base for my woodworking machines bandsaw, jointer, drill press. I have never bought steel before so any advice would be helpful since I don't want to spend more than I need to or buy the wrong stuff. I will be flux core mig...