MongoTA's latest activity

That's unfortunate. Worst sticking we had was once when my wife wiped the wood peels down with a damp towel without me knowing. The...

Fantastic!

Very nice!!

Got to the point where it was time to rebuild my air nail guns, so I thought I'd look at battery powered to make some small jobs easier...

I'm in the northeast and I love old iron. At auction, those drill presses often go for less than $100. Yours looks in good shape, it's...

Everything in your Post #6 sounds proper. I mortared up a stone wall back in 2022, it's about 120' long and about 3-1/2' high. I dug...

It may be a version of a "hand cannon", sometimes described as a signal flare launcher. There's a touch hole on the side, near the...

The part circled in red is to help the truss designer with layout, it's likely that it should have been deleted from the end drawing.

I'm way late to this party, but with no follow up maybe you haven't finished up? I'll throw another alternative, I did quite a few face...

Going out on a limb here, but are you referring to this, below in red? If so, I'd refer to that as a "gap" between two boards. If that...

Would a basic crowfoot or perhaps a flare nut crowfoot or flare nut socket work? Sometimes they have different names. Can't quite make...

Flat stones, I'd not bother. I suppose there's a way, but I don't even want to think about it. Much easier to use a wheel on a bench...

Run a file across the edge and see if the file cuts or if it skates across. If it skates, it could be hardened steel.