Recent content by Motor2Wheel

Thanks, Man, for the link. I checked it out and looks good. Here's my new dilemma: I was hoping to replace the B-vent with the SS directly, in other words, use the same thimble and not have to replace any of the work I had already done in that area. This might not be the case now. Can you...

Lesson learned.... I'm going to upgrade to Cat III. Thanks for the input.

Thanks, guys. I am going to upgrade the system to Cat III so everything is good. Should be pretty straight-forward at this point, as long as everything fits with the new pipe.

Thanks Man, I believe you are correct from what I have been searching here: http://www.duravent.com/docs/product/L915_W.pdf I thought it had to do with the seals between joints, but I believe it is corrosion resistance. I just used B-vent on a new installation and will make a note to...

Thanks, Bill, you are correct and I reviewed this in my installation manual. I did utilize connector hardware and fastening screws as also outlined in the instructions to join the sections together. I will also be putting in an CO sensor to keep it even more safe for me and anyone else, but...

I forgot to mention that I can touch the vent pipe after the heater has been running for a while, not for long of course, but it really gives me comfort knowing that it doesn't get too hot. Thanks.

We have a low ceiling height in the shop, but were able to hang the heater with the 5' min floor clearance just fine. I was concerned with the spray foam insulation coming into contact with the vent pipe and wanted to pay real close attention to this. After the heater was hung, I punched the...

I just installed a 100K Hot Dawg into my barn project. I'll be running the vent and gas this week. The shop area only has 7' ceilings with exposed beams. It is kind of low, but situated in the corner where I won't be storing anything. The insulation is foam on the walls and fiberglass on top...

Working on an old barn project and have been looking around here for a while now. Thought maybe it was time to sign up.