Recent content by MountNMan56

The power vent fan runs constantly, the blower fan comes on and runs for about 5 seconds, then shuts off, then, the ignitor clicks and the gas lights and stays on for about 10-15 seconds, then goes out. Then it starts all over again. I watched this today.

No, the power vent runs fine, it's the main fan that blows the heat.

Run 12/3 wire. 1 circuit on the " Red " wire and the other on the " Black ". They will share the neutral. Put them on 2 separate 20 amp breakers in your breaker panel. That way, you can run 2 circuits by only pulling 1 wire. You could run the 12/3 wire in to a 4 square junction box, then come...

There is a sensor there, but it does not have a reset button on it.

I checked. It flashes 4 times. It say's that the limit or rollout switch maybe open, however, I can't find one on this unit. This is a 150000 BTU unit, Model TF/BTU150

I just found this site. I am a Residential Journeyman Electrician and also work in a lab for a huge Polycarbonate company and as a Taxidermist. Look forward to helping and getting help from all of you. Thanks

Can lights

Just take the wires off of the switch and splice them together and put wire nuts on them. Done.

20 Amp, 2- pole according to your description

I haven't done that. I will do that and get back. Thank you

I have a nat. gas heater in my shop. Lately, it lights and heats up, but the fan only comes on about 1/2 speed for about 5 seconds then shuts off. Any ideas?